Clarity INT9 A/D Uživatelská příručka stáhnout pdf (Strana 56)

Clarity - Getting Started Troubleshooting

From the list of equipment allocated to the

instrument, take the Detector x from DEMO

driver field and draw the correct detector of

the A/D card you are using from the list on the

left.

If you only have Demo detectors in the left-

hand Setup Control Modules list and your

A/D card is missing, open the

Available Control

Modules

dialog and using the Add button add it

to the configuration of the station. Then repeat

the previous step.

7.3.3 Other Error Messages

You can find the description of other Error

Messages and possible problems and solutions

for them in other manuals. Here is the list of

known possible Error Messages with reference

to their descriptions:

• Board Malfunction (INT7, INT9)

• Cannot create detector (INT7, INT9)

• Cannot find driver file

\\.\CSWINT70 (INT7)

• Cannot find driver file

\\.\CSWINT91 (INT9)

• Cannot load device driver (U-PAD)

• Cannot find first board (INT7, INT9)

• Cannot find second board (INT7, INT9)

• Card not found (INT7) – only older stations

• Error Occurred During Setup (INT7, INT9,

U-PAD)

• Cannot establish communication with

DataApex U-PAD (U-PAD)

Note: Some of these error messages can also appear if

using another hardware than it is listed above.

The remedy for such error message should be the

same for any device installed. Actualized versions

of Clarity Hardware manuals can be found on the

DataApex website (www.dataapex.com

1 2 ... 51 52 53 54 55 56 57 58 59 60

Žádné komentáře

Clarity INT9 A/D Uživatelská příručka Strana 56