Clarity INT9 A/D Uživatelská příručka stáhnout pdf (Strana 49)

Clarity - Getting Started Connecting Autosamplers

utilize the OUT

R digital output cable. All

timings are governed by the chromatograph;

Clarity only performs one analysis for each

start signal received. All synchronization only

includes external start up of data acquisition

in Clarity using the IN

starting cable.

Fig. 20. Wiring of an autosampler in Passive Sequence

A Passive Sequence has to be used e.g. in the

sets with Headspace autosamplers (without AS

Control module).

Caution! It is not recommended to use the Passive

Sequence together with the Control modules.

Note: Detailed information on using Passive Sequence

can be found in the Clarity User Guide.

6.1.4 AS – Active Sequence + AS Control + A/D card

When using the optional AS Control (p/n A26)

module, all communication is performed through

a separate data cable (usually a serial cable

connected to a COM port).

Caution! Refer to the corresponding Clarity Control

manual for wiring specific to your control

module.

Following scheme corresponds to the set with

directly controlled autosampler without using the

digital acquisition, when data are acquired using

an A/D converter (INT7, U-PAD).

In such a case do NOT CONNECT

the digital

output cable OUT

The starting cable IN

MUST BE CONNECTED.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 59 60

Žádné komentáře

Clarity INT9 A/D Uživatelská příručka Strana 49