Clarity INT9 A/D Uživatelská příručka stáhnout pdf (Strana 47)

Clarity - Getting Started Connecting Autosamplers

Variant B - started by opening the contacts

In the second scheme there is autosampler

wiring that conversely waits for output

contacts to be opened. This requires different

connection (marked by circle).

The OUTPUT and READY contacts are

connected parallel to each other and the

autosampler will start its operation after both

contacts are opened.

To have the contact on the INT7 board (INT5 or

U-PAD) closed in the initial state, it is

necessary to set the Output Initial item in the

Digital Output Control dialog (accessible from the

Clarity main window) to LOW.

Fig. 18. Wiring of the autosampler – variant B

Note: The start output mapping of the Clarity to

individual digital outputs of the A/D converter can

be set in the bottom-right corner of the

System

Configuration

dialog (see Fig. 2 on p. 15). A

detailed description can be found in the Reference

Guide.

6.1.2 AS + LC set – Active Sequence

In LC systems, the autosampler typicaly governs

the timings. The eventual pump gradient or

detector programs are set independently.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 59 60

Žádné komentáře

Clarity INT9 A/D Uživatelská příručka Strana 47