Clarity INT9 A/D Uživatelská příručka stáhnout pdf (Strana 45)

Clarity - Getting Started Connecting Autosamplers

time. The sampler is thus synchronized with the

GC by a signal wire (READY), alowing next

injection only after the GC gets to the READY

state. The Autosampler performs the injection

and starts the GC using another signal wire

(START). Any autosampler that is used in the

Clarity Active Sequence without

an AS Control

module must be synchronized by cable with the

Clarity station as well as with a chromatograph.

The IN

starting cable should be plugged into

the synchronization output (INJECTION) of an

autosampler or GC. The OUT

R cable should

be connected to the synchronization input

between GC and autosampler.

Note: Further information about Active Sequence is

available in chap. 4.3.2.2-3.of the Clarity User

Guide.

All commonly used autosamplers may be divided

in two groups:

• Autosamplers started by closing the contacts

on the input (

EADY

• Autosamplers started by opening the contacts

on the input (READY).

Variant A - started by closing the contacts

The first scheme displays the wiring of an

autosampler that is preparing to inject after

closing the contact on its input.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 59 60

Žádné komentáře

Clarity INT9 A/D Uživatelská příručka Strana 45